At Easylife we know that it is vitally important for the health of any machine to be serviced at regular intervals. But, all machines need top be serviced properly competent trained service personnel.
At Easylife you can rest assured that your equipment is being looked after by some of the best people in the industry. Please see below the comprehensive servicing schedule that we carry out to make sure your machine stays in tip-top condition.
Silver
Change engine oil & oil filter*
Change spark plug
Clean/replace air filter
Replace fuel filter
Clean out fuel tank *
Sharpen and balance cutting blades
Lubricate grease points
Check oil fluid levels
General check over machine
Check and inspect all safety covers/guards/features
Run final check using Aspen fuel
Test operation
2nd inspection and checks
Change spark plug
Clean/replace air filter
Replace fuel filter
Clean out fuel tank *
Sharpen and balance cutting blades
Lubricate grease points
Check oil fluid levels
General check over machine
Check and inspect all safety covers/guards/features
Run final check using Aspen fuel
Test operation
2nd inspection and checks
Gold
Change engine oil & oil filter*
Change spark plug
Clean/replace air filter
Replace fuel filter
Clean out fuel tank*
Sharpen and balance cutting blades
Lubricate grease points
Check oil fluid levels
General check over machine
Check and inspect all safety covers/guards/features
Run final check using Aspen fuel
Test operation
2nd inspection and checks
Change spark plug
Clean/replace air filter
Replace fuel filter
Clean out fuel tank*
Sharpen and balance cutting blades
Lubricate grease points
Check oil fluid levels
General check over machine
Check and inspect all safety covers/guards/features
Run final check using Aspen fuel
Test operation
2nd inspection and checks
- Lubricate starter and check gear
- Wash and clean tractor and cutter deck
- Check and test transmission
- Inspect pulleys
- Check and lube linkages
- Check and lubricate steering
- Test brakes set*
- Check tyres and pressures
- Check battery charge and condition
- Remove cutter deck* and inspect
- Check and lubricate bearings, shafts & belts
- Reset cutting belt tension